Abt C5

[zlobo]

Wow. Nice torque wrench. Did it take long to train for that job?

Audi original Yes a lot of beer

[zlobo]

Your dunlop direzza's what code are they I can't find the tread pattern.

They are brand new just realesed,

[Corey]

They are brand new just realesed,

yeah thanks, I gathered that as I couldn't find them. I was hoping you would put the code up to make it easier for me to find

[zlobo]

yeah thanks, I gathered that as I couldn't find them. I was hoping you would put the code up to make it easier for me to find

This is what it say on the recipt "Dunlop direzza O2G M2 000010 668143"

[zlobo]

did some testing to se if i kan fit the generator on the oposite side..
in the end of the week i am going to lift in the botom of the engine and do some work on the fuel lines and im and other stuff.

[olsonjus]

Very nice thread! Where are you placing the power steering pump? Also, what size injectors are you going to run with E85. It is just starting to become available around my area, and I'm thinking about running it with 1600cc injectors and dual 044 pumps like you.

Regards,
Justin

[zlobo]

Very nice thread! Where are you placing the power steering pump? Also, what size injectors are you going to run with E85. It is just starting to become available around my area, and I'm thinking about running it with 1600cc injectors and dual 044 pumps like you.

Regards,
Justin

Thnks man, i am planing to place it where the generator shuld be. The injectors is going to be bosch 1600cc injectors cause they spray very nice.

[Greg_S]

What exhaust manifold are you using?

[zlobo]

What exhaust manifold are you using?

part self made and mostly by a frend. going to build a new next meybe winter depends on what kinde of figures i get..

[Greg_S]

Looks a little like an RS2 copy, is that what it was modelled from?

[zlobo]

more like sportquatro then but basicly we looked around a bit.

[zlobo]

got the flanges for a new project next winter,,,

[zlobo]

lifted in the block today.. now i am only waiting for a flange. and then i am going to order some more parts, like injectors.

[zlobo]

some more pics..

[zlobo]

My New 1600CC injectors flowcheked and reddy to use:mischeif: . Not much happend since last time
Started to to some drawings on my dual plenum, cant start to bould it until i get my flange. my frend will do some flow calculation on one of the drawings.