Bens Audi 80 track car project

[terrybullwon]

https://m.youtube.com/watch?v=ffHg80Ut0Mk

Went out for the first proper test this Saturday at castle combe
Only running 1.4bar as were still running her in

Very good effort. First track day, in a car thats only on 100 + miles

[bigcooler]

https://m.youtube.com/watch?v=ffHg80Ut0Mk

Went out for the first proper test this Saturday at castle combe
Only running 1.4bar as were still running her in

[Albert]

Did you have time and weighted the car? Balance front/rear?

[terrybullwon]

Those dampers IIRC they are Audi Sport but what type of valving / service parts do they use?

Digressive with linner rebound, Koni parts still on the shelf!

[Mcstiff]

Those dampers IIRC they are Audi Sport but what type of valving / service parts do they use?

[Greg_S]

Thats a hell of a transformation. Cant be long until you will both be out on track

[Thuppu]

Everyday grandpa transformed to ultimate killing machine! Nice!!!

[terrybullwon]

This now has a MOT

Had to fit a race cat but its 100% legal

So we have gone from this to this

[terrybullwon]

[terrybullwon]

Sounds very similar to my setup, l also kept the original pump to circulate water around the block whilst the engine is warming up and switch the elec pump on at around 75c, the fans never come in unless the car is stopped.

I think were see better results on track when its not so stop start with this

My car with the same set up but custom made rad can do multipul laps with out the fans coming on now. Its defiantly dependent on how efficient the rad is

[gnutz2]

Thanks Baz

It's on a 150 Craig pump with the internal one still there.

Water temps seem consistent at 84 according to the data

Sounds very similar to my setup, l also kept the original pump to circulate water around the block whilst the engine is warming up and switch the elec pump on at around 75c, the fans never come in unless the car is stopped.

[terrybullwon]

Great work

What pump(s) are you running for the rear rad? and remember if cooling is borderline then changing that rear rad will gain you 20% better cooling.

Thanks Baz

It's on a 150 Craig pump with the internal one still there.

Water temps seem consistent at 84 according to the data

[gnutz2]

Great work

What pump(s) are you running for the rear rad? and remember if cooling is borderline then changing that rear rad will gain you 20% better cooling.

[terrybullwon]

Hi! Nice Project you have there Can you tell me the part number of this release bearing or it is custom made?

Tilton bearing home made face

[Newmember]

Hi! Nice Project you have there Can you tell me the part number of this release bearing or it is custom made?