wanted clutch slave to master pipe

[WabTheKing]

wanted clutch slave cylinder to master cylinder pipe
must be off a RHD aby coupe
7A/3B one catches on the linkage and is now ******* fluid out!
cheers
will

[BRY]

Is this a flexi type, there is a place I use that can copy / extend / shorten hydraulic pipes to whatever you want, and they can do it while you wait - most of the time.
Fancy a drive?
You could take the sooty van for a run over the hill if you haven't sold it on t' Fleebay.

[SteveH]

I made one from Goodridge hose, much cheaper than the OE pipe..Get a 90 degree fitting for the master cylinder end

[WabTheKing]

im just being lazy and want to put it straight on, its solid at the master end, got a flexi in the middle and then solid where it goes into the slave, its the solid bit on the end that goes into the slave which has a hole in it,

tried ringin sal to see if he has one - but no answer

someone looking at the sooty van now!!!

ill let him haggle with sweep over the price!!!

[BRY]

It's too early for Sal
Give him an hour
I wouldn't want to haggle with Sweep

[WabTheKing]

steve, did you just do it in one piece 90' angle on the master end and straight into the slave?

cheers
will