Announcement

Collapse
No announcement yet.

01E 6spd S2/RS2 shift linkage

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 01E 6spd S2/RS2 shift linkage

    Looking for a 6spd shift linkage from an S2/RS2 to do a FWD 6spd conversion on my cabrio (have just sourced an ARX box from C4 2.5TDi)

    Ideally the whole lot, shifter, linkages and the spider from the gearbox if possible

    Thanks!

  • #2
    I have the spider, the shift lever, gear knob and new OEM rubber boot for the bearing. The 2 parts of the linkage I have are no good.

    If you find the rods, maybe is useful to you...
    Honda CBR 1100XX Blackbird Turbo....undergoing major changes.....
    S2 Coupe... bit easier off the line...
    '03 ZX12-R daily hack.... lots of nice bolt ons...

    Comment


    • #3
      Definitely interested, as I've not had much luck finding any of these bits...

      I did get the gearbox side of the shift linkage with the ARX box, but highly doubt they will fit the B4 chassis .

      How bad are your linkage bits? Could I use them to get dimensions to make up new rods or use the connection ends?

      Comment


      • #4
        Are you in a rush? I have a new batch of my 6 speed linkages coming in 4-6 weeks
        Panthero Coupé quattro 20vt
        Indigo ABY coupé
        Imola B6 S4 Avant

        Comment


        • #5
          No rush, this might end up being the best way forward and avoid a whole load of adjustment cutting and bending - what does your linkage include?

          Comment


          • #6
            It is a complete bolt-on linkage based on the B5 and later 3 rod system.
            Panthero Coupé quattro 20vt
            Indigo ABY coupé
            Imola B6 S4 Avant

            Comment


            • #7
              my advice... go with this....
              Honda CBR 1100XX Blackbird Turbo....undergoing major changes.....
              S2 Coupe... bit easier off the line...
              '03 ZX12-R daily hack.... lots of nice bolt ons...

              Comment


              • #8
                I'm thinking that also, it sounds very promising!....Not sure if I need a spider or shifter (mine is 5spd) though?

                Comment


                • #9
                  Nope, you won’t need any existing linkage parts, my linkage is a complete bolt-on
                  Panthero Coupé quattro 20vt
                  Indigo ABY coupé
                  Imola B6 S4 Avant

                  Comment


                  • #10
                    might need a knob.....?
                    Honda CBR 1100XX Blackbird Turbo....undergoing major changes.....
                    S2 Coupe... bit easier off the line...
                    '03 ZX12-R daily hack.... lots of nice bolt ons...

                    Comment

                    Working...
                    X