Need to source a part for my project car...anyone recommend a good breakers for VW 'flogs'?
-
Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.uk -
What bit is it you need? new or old part?
German Recycled Audi Spares
Hockcliffe Business Centre, Unit 11
Watling St, Hockliffe, Leighton Buzzard, LU7 9NB
01525 210978
any help? -
.
25mm wide camshaft sprocket to fit Audi IL5 cam, possibily from mk2/3 golf?Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
-
Volksmania, just off the A46 about 5 miles outside of Nailsworth, south of Stroud, nice little drive from Glozzar.Cheers'en, AndyC
1994 ABY Coupe - Projekt AlpinweissComment
-
Hmmm...
Telingbone number...sozzy, i've ben on the old rosie 2nit...hic...
Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
-
Jay - pug_life85@hotmail.com
1986 Audi UR quattro - WORK IN PROGRESS
1981 VW Mk1 Golf - "20v Jim, but not as we know it!"Comment
-
01454 329 990, Mark or Paul there will sort you out, they've got everything.Cheers'en, AndyC
1994 ABY Coupe - Projekt AlpinweissComment
-
.
Jay...that's the prob, not quite sure. It's a case of getting the bits in my grubby mits and checking the fit.
It needs to fit on to a 7a ex. camshaft, if that helps.
Cheers Andy, i'll give em a bell.Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
-
i have a few 25mm pulleys. they are off basically all 16v golfs. they fit a non COP cam no worries but would sit very close to the engine. they are not concaved enough to clear the hall sensor.
do people usually not go 60-2 for timing before they do this?
i have had a problem with what appears to be a bent 7a cam duing my rebuild and have sheared off 2 keyways on aby pulleys hence my reason for needing pullies in previous posts. i tried a 6a/9a and a kr. they are both the same. when you look at the back of the pulley (tyhe mounting surface) the aby one has about 1/2 inch of offset whereas the 16v is flush.Comment
-
.
My cam timing is going somewhere far simpler...i hope:mischeif:
Thanks for info.Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
-
Still looking for one of these...
This is the 7a one, fits onto a 20mm shaft and the distance from the rear belt edge to the mounting surface is 11.5mm.
So i need one that checks out with the above but is 25mm wide...anybody?Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
Comment