S2 drive flanges WANTED

[goodall]

Hi, looking a set of drive flanges so can convert my 90 to 5 bolt

Or if you have a set of complete hubs would also consider

[goodall]

No one?

[Acidburn]

Flanges or hubs? just to clarify.

[JMLAudi]

Swop over

Hi

if you running a KV 5 cylinder Audi 90 then you will have issues with the driveshafts and gearbox flanges in front

at the rear the outer cv joints will work with the Audi S2 5 studs hubs but in the front if you use the driveshafts from S2 you will have to use a 20V gearbox or a S2 gearbox

that was the way i had to go................UNLESS someone here has been fortunate to suss the problem out

hope this gives and idea

cheers
john

[goodall]

Flanges, just

I have 20v running gear, which makes a bolt on swap as far as I knew

[Acidburn]

ok well i've got the rear s2 hubs still

might know of a pair of front one's but will have to find out.

[goodall]

Acid, sounds good, do you have access to a press as to save on postage?

[topsparky]

will s4 ones do i've got a full set

[Error404]

don't need a press you can pretty easily hammer them out with an appropriate sized drift

[goodall]

Topsparky I believe they do, rear press straight in and front need little machining, will have check on motorgeek

Error, fair point really only really need the press to remove actual bearing

[goodall]

Need to put this on hold as, christmas has cost bit more than I was expecting


Bah humbug