Wanted: Internal ECU vacum hose + 2 clips

[Colesy]

Looking for a replacement hose that goes from the map sensor to the tube that goes to the outside of the ECU (excuse the terminology) does anyone have some of this or know where I can get some?

[UrS4boy]

Looking for a replacement hose that goes from the map sensor to the tube that goes to the outside of the ECU (excuse the terminology) does anyone have some of this or know where I can get some?

You mean the one shown in the photo below. Not a separate OE part. Shouldn't be too fancy. Needs to be able to take 35 psi (2.5 Bar) boost and 30 inche (760 mm) of mercury (Hg) vacuum. WHY do you need one? Never heard of one failing before.

[Colesy]

Yes that's the one, the old hose hasn't failed it was just borrowed to put into another ECU which had too short a hose for the new map sensor.

[UrS4boy]

"Neither a lender, nor a borrower, be"

[Colesy]

I was the lender and the borrower in this instance! Nicked it from my spare!

[AndyP]

http://cgi.ebay.co.uk/4mm-BLUE-SILIC...item43a79d367f

If you can't get the clips use cable ties or super glue

[prj]

No super glue! That's a pita to take off.

[Colesy]

Cheers guys all sorted.

[UrS4boy]

Cheers guys all sorted.

No, no, no, no, NO. You *have* to tell us *HOW* you sorted it

[Colesy]

Well, I had some 4mm vacuum hose in storage from when I installed my boost gauge - didn't realise that the hose was the same for inside the ECU. For clips I used some small tie wraps which did the job nicely.

[prj]