Wagner SQ Manifold

[Street_Rod]

Hello,

looking for a Wagner SQ Manifold. Must be new or in perfect condition.

THanks

[Jamo]

Contact Wagner directly ie send a message to Lupo911 or MarKB

[djh]

as above if your after new or in perfect condition you'd have to pay top dollar so might as well just go direct and not have any issue's.

[Jamo]

They had 1 sq manifold at a reduced price from the show, whether europeanme has pulled his finger out and bought it is another question.

So get contacting!

[Street_Rod]

Thanks for your replies.

The problem is I dont wanna pay the 850 for one at Wagner, I think this is quite a lot. Maybe there is somebody who has one and has changed his plans and wants to sell it. Like me I have a brand new Wagner EVO Manifold with T3 Flange here. But nobody wants to pay the 720,- Euros I did...

Maybe someone wants to trade?? Of course with some extra charge for the SQ Manifold to my EVO

[Jamo]

Well no harm in trying but I think your chances are slim there

[Rocco]

and why you dont want to keep your T3 RS2 EVO manifold? i bet that will be more than enough for your project

and much more for street driving over track days....

RS2 EVO manifolds are good for 550/600Hp FOR SURE¡¡

good luck¡

[Jamo]

Depends on your turbo Rocco, remeber I've just done this gone from a T3 evo to SQ because I needed the extra space for the larger compressor housing and chassis rail clearance

[Rocco]

Depends on your turbo Rocco, remeber I've just done this gone from a T3 evo to SQ because I needed the extra space for the larger compressor housing and chassis rail clearance

yes i understand...and problably something bigger than GT3076 could be a problem...

but,is it not possible to fit a T3 flange spacer,of around 1cm...and make it able to fit?

[Jamo]

You can but that only covers the compressor housing to manifold clearance you still have chassis cleaance issues

Plus the SQ is a sexy beast

[europeanme]

They had 1 sq manifold at a reduced price from the show, whether europeanme has pulled his finger out and bought it is another question.

So get contacting!

who me....

[MarkB]

Sorry guys I don't have a SQ manifold here.

I do have an RS2 Evo manifold here (T3 flange) and other bits ...

[Street_Rod]

OK, here's the plan:

I have a Garrett GT3076 A/R .82 and T3 Flange and the Wagner RS2 Evo Manifold. Cyl head is original and NOT ported. H-Beam Rods, Bosch 044 fuel pump, 3" Downpipe and exhaust system. Further the short Wagner EM and the Intercooler is planned. Do you think this setup is enough for about 450-470 hp??? My problem with the RS2 EVO EM is the restricted clearance to the chassis...

What do you think??

[Jamo]

I ran that exact setup on a 2.5 stroker
Rwd19t runs it so does Rocco with the same turbo
It is 110% fine

[Street_Rod]

How much HP did you achieve with this setup?? So you think the SQ manifold is not needed??