You can use one from the original connecting rod end...
-
-
Damper bracket
On the picture it does not show the throttle damper bracket , I've been after the 2 bolts that hold it on (the ones you have to remove to change the plugs) as mine are well mankey anybody got a part numberComment
-
these are nla....I've spoken to my parts guy and you have to buy the whole throttle body to get one and you cannot check the thread size on etka!!...yet they show the majority of other threaded parts....what a bu99er...
Comment
-
If that's true it shouldn't be too hard to find some?Comment
-
Like the nut that is the original subject of the thread, those two Torx-headed screws are not listed as separate parts, i.e. they are integral with the throttle body. That said, I would just remove one, check the thread size, e.g. M5x1, and then go to a fastener store and buy some shiny stainless steel allen head bolts and replace the "manky" Torx ones.
On the other hand, if you are talking about the allen-head bolts that hold the throttle body assembly to the intake manifold then the PN is N 10080102 (M6 x 25).
Here they are (both types discussed above) on an AAN throttle body (ABY photo below):
Last edited by UrS4boy; 26 September 2012, 14:42.RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avantComment
-
It was the torx-headed ones I was asking about and yes i was going to find some allen headed ones
CheersComment
-
Nut size is M10x1.25ChefComment
-
That's odd!ChefComment
Comment