B4 to 5 cylinder engine conversion mounts

[rennenmsports]

I am looking for a way to put a 5 cylinder 20v turbo engine into a B4 V6 chassis

[Ruffiano]

Your inqury will be confusing to most Europeans. In Europe the same b3 mounting legs were used in the b4 chassis, because if you purchased a b4 with a 5 cylindee it had the same welded in mounting locations in the engine bay. The euro v6 engine bay were the same as the US market engine bay. There is no factory mount to do what you want to do.

[80Quattro]

You need to get the mounts from a B3/4 with a 5 cyl, they are welded to the chassis rails rather than bolted like the the 6cyl. Cut them out with a bit of chassis rail and then carefully remove on the bench would be my advice, or you can probably buy them new from Audi, P/N 8A0 803 029 B & 8A0 803 030 A. You'll have to weld them in, obviously!

[rennenmsports]

I see. Sorry and Thank You! I did not realize that was the case. I need a chassis for my motor and am looking at a 1995 Audi 90q 2.8L V6 5 spd. right now. Wondering if I could make it work.

[varia]

I see. Sorry and Thank You! I did not realize that was the case. I need a chassis for my motor and am looking at a 1995 Audi 90q 2.8L V6 5 spd. right now. Wondering if I could make it work.

you could, many done it before you.