Specs for the original oil temp sensor on 3b/aan/aby/adu eng

[quattrofrank]

Hi

I have wired a vipec engine management and a aim dashlogger in my audi s2. I need to calibrate the original temp sensor for the oil, but its no info about this. I guess my only option is to take it out, boil it in water and measure the resistance on different temperatures. Unless somebody already have done this?

The same problem is with the fuel level sensor

[quattrofrank]

Nobody used the original temperatur sensor connected to dashlogger or ecu before?

[terrybullwon]

I am interested in this to I need to set mine up with my dash, what's the original bosch part number ? Maybe this would help find the info

[quattrofrank]

Its not bosch sensor, its from VDO. I looked through the VDO catalogs, but i couldnt find it in there.

[quattrofrank]

Original part # 035919521B
Temperature range: 0-180 celsius

[4WheelDrifter]

The good book uses a VAG 1301 to test the gauge, but I can't find any info on the sender.
Heat up some oil, use a thermometer and measure the resistance. Easy job for a chef.

[terrybullwon]

The good book uses a VAG 1301 to test the gauge, but I can't find any info on the sender.
Heat up some oil, use a thermometer and measure the resistance. Easy job for a chef.

Yeah i have all the tools for this Job

[quattrofrank]

Is it possible to check and post it here? After some searching the web I found this http://www.clubgti.com/forum/showthread.php?t=214035
But thats for the wrong type of sensor. However, they say that it some info in the haynes manual. I belive the 7a engine uses the same sensor. Maybe someone have this manual and can check?

[quattrofrank]

Spoke to VDO an got the calibartion table sent by email. Great Service by VDO
Attached is the sheet I got in case someone needs it in the future