Race-technology Dash 2 Set up with IL5 and sensors

[terrybullwon]

I guess this thread will help people fitting or already fitted a dash to a IL5

I am looking for any information on the Gear indication using a 6 speed box

And if any one has already scaled the standard oil pressure and water temperature sensor this would be a great help.

I am setting mine up tomorrow with alittle luck its all wired in now and just needs calibration and some testing

[terrybullwon]

Heres my set up

Tatech pro 32 ECU
Custom motor loom
Race Tech Dash
Data logger
Own made wirring looms

Sensors
2xEGT's
2xWB02
1x k-type low temp for oil
Standard water
Standard Oil pressure
RT Oil temp
VRS signal conditioner to stock ABS sensor
Linner pointer-meter on throttle pedal (not fitted)
Linner pointer-meter on Brake (not fitted)

Theres more to add but i'll see if any one wants to contribute i know Hamish will be interested

[terrybullwon]

Bump

[Jamo]

There's no direct output from the gearbox to say what gear it's in by default AFAIK, aftermarket have to use speed based calculations, have you got a sensor installed so it indidcates what gear?

[terrybullwon]

There's no direct output from the gearbox to say what gear it's in by default AFAIK, aftermarket have to use speed based calculations, have you got a sensor installed so it indidcates what gear?

Ah Mr Jamo

It's a gear equation for the gear number display you can configure it to any box or transmition set up of course wheel size will also efect it

[terrybullwon]

http://www.race-technology.com/configuration_software_dash2_2_40.html

[Jamo]

Similar calculation then

[pnanassy]

just switching to sdl3,so if anyone needs a similar setup (its upgraded however with a custom made fuel prediction unit and with a wheel speed signal conditioner) let me know.

i used the oil press switches on my setup.on a previous one we tried to calibrate the stock audi oil pressure sender,but it was not fully ok for the rt dash2.