Vems Hard Start Problem

[KRIENG]

0.5 Sec ( 3.49-4.03 ) Sec In data log

Please advise me.

[cooperquattro]

you using 1.1.96?? this has a known cam sync issue on start up

[KRIENG]

Fixed down to 1.1.95

Thank You all

[Wrath]

Im using 1.1.96 myself and i think it takes a little longer then with the motronic, what are your symptoms? Was hoping to test the 1.1.95 but the 1.1.99 is coming soon and then the problem should be gone...

[Billman]

I dont have any/many issues with 1.1.96. Starting took a little longer but it is much better with changed settings.

[Wrath]

okey, my starts in 2 engine turns or how you say so i guess that´s kinda normal...

[Jamo]

No difference between 1.1.96 and 1.1.95 to the Audi install hence I don't run it, waiting for 1.1.99 or whatever the next release is

[Wrath]

My tuning guy said that all the Audi car he has tuned start´s quicker with 1.1.95 firmware then the 1.1.96 but he told me to wait for the 1.1.99 that´s around the corner...

[Jamo]

They will do as 1.1.96 has a bug in it

[KRIENG]

same setting 1.1.96 take 0.5 sec - 0.8 sec (170 to 405)
1.1.95 take 0.3 sec (198 to 503)

base time count by RPM >150 to RPM > 300

[Billman]

[1.1.99] - NOT released (only for testing, eg. Fero's Nissan 360 tooth !)

test results welcome, of course
recommended to verify wbo2 free-air calibration and check nernst voltage is appr. 4.5V (0.45V above pump-)

[Wrath]

http://www.vems.hu/wiki/index.php?page=IssueReports

[popdemonic]

Down to 1.195 cranking is shorter than 1.1.96 .i tested it today.it just takes slightly longer than moronic.i will try to tweak ve and timing a bit for a better result.

[KRIENG]

[1.1.99] - NOT released (only for testing, eg. Fero's Nissan 360 tooth !)

test results welcome, of course
recommended to verify wbo2 free-air calibration and check nernst voltage is appr. 4.5V (0.45V above pump-)

means calibrate WBO2 again when downgrade to 1.1.95 ?

"nemst" voltage I don't understand please tell me more.