Hi Chaps,
this evening after i have read the write up how to use the misc output controlled
N80 in VEMS.once i pulled the vems off i was so surprised that the EC36/36 was
already in used.i could n't find where the wire goes to another end.I also
found that on the pin#5 of motronic was already soldered to the EC24/36 on the vems.
EC24/36 is also the same as EC36/36.It's available for ignition driver(I259,EC24,Channel#6).i assembled the vems.on the vemstune i tried to
enable the misc 1 and choosed the EC24/36 channel 6 and inverted.
i found the engine is running a bit roughtly with slightly backfire on the exhaust
pipe,lambda no changes.i checked the n80 once i pulled off the hose on the connector
side.i found there's still vacuum trying to drool up the gas fumes from the tank.
i tried to connect/disconnect connector there's no changes.it seems there's no
power to energize the n80 valve.no clicking sound via the n80 valve.
anything i did miss on it?
this evening after i have read the write up how to use the misc output controlled
N80 in VEMS.once i pulled the vems off i was so surprised that the EC36/36 was
already in used.i could n't find where the wire goes to another end.I also
found that on the pin#5 of motronic was already soldered to the EC24/36 on the vems.
EC24/36 is also the same as EC36/36.It's available for ignition driver(I259,EC24,Channel#6).i assembled the vems.on the vemstune i tried to
enable the misc 1 and choosed the EC24/36 channel 6 and inverted.
i found the engine is running a bit roughtly with slightly backfire on the exhaust
pipe,lambda no changes.i checked the n80 once i pulled off the hose on the connector
side.i found there's still vacuum trying to drool up the gas fumes from the tank.
i tried to connect/disconnect connector there's no changes.it seems there's no
power to energize the n80 valve.no clicking sound via the n80 valve.
anything i did miss on it?