Hi now i have everything in order and the bank balance is building up ready for the bashing from my porsche brake upgrade i just have a question about the carriers. I am going to get the seat cupra type r carriers and get them machined down. Does anyone no where to get them machined down? Also would it cost alot to get them done? I heard fourings does it i have pm'ed him but not had a reply. Anyway thanks for your help
-
3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips
(just need the RS2 Airbox) -
Try yellow pages for a local CNC machine shopsigpic
Tom C - www.rcmr.co.uk
Audi UR Quattro
Audi 100 C3 2.0 5 cyl 115ps
Audi S2 - 07k engine project aiming for 800ps
Audi B5 RS4 645ps 911nm -
I just did mine myself.
SSComment
-
Do u fancy doing mine i pay well
3'' Longlife Exhaust, Koni Adjustables, H&R Springs, Full RS2 Setup with Mr Nugents RS2 Chips (just need the RS2 Airbox)Comment
-
I'd also like to know how much you milled them and what side... You know, a basic "how"...Comment
-
Hmm... I can't remember how much I took off.
I just offered them up, then milled whatever needed to come off. 
I'll have a look.SSComment
Comment