braided hoses for porsche brakes

[tango123]

Does anybody know which braided lines i could use on the common 4pot porsche brake conversion. The reason being, i will be able to move the caliper out of the way when carrying out any work as opposed to the metal pipe which would need removing.
Thanks for any help!!

[Henkjan]

I had them made by Goodridge

[jeffstoo]

I did mine like this. The hose from arch to strut is part of a generic kit (Earls i think). The hose from strut to caliper I had made up at Merlin motorsport.

[tango123]

Thanks for the replys, gives me an idea.

[recurveandy]

I had single lines made by HEL, specs below
Need to make a small cut out in the bracket to take the grommet, otherwise you'll need two as pictured by jeffstoo above

Colour
Transparent
Fitting One
Swivel Male - M10 x 1.00
Fitting One Angle
70°
Fitting Two
Fixed Female - M10 x 1.00
Fitting Two Angle
Straight
Support One
Rubber Grommet
Support Two
Rubber Grommet
Heatshrink
None
Length
64cm

[LHD_Kid]

Go with HEL. Just superb quality....

[AndyP]

I've got HEL lines too, great quality and VFM.

[Error404]

Another vote for HEL

[tango123]

I had single lines made by HEL, specs below
Need to make a small cut out in the bracket to take the grommet, otherwise you'll need two as pictured by jeffstoo above

Colour
Transparent
Fitting One
Swivel Male - M10 x 1.00
Fitting One Angle
70°
Fitting Two
Fixed Female - M10 x 1.00
Fitting Two Angle
Straight
Support One
Rubber Grommet
Support Two
Rubber Grommet
Heatshrink
None
Length
64cm

64cm?? wouldnt that be too long?

[Error404]

Single piece
I did mine the same way

[tango123]

ordered same as the above but with a banjo fitting, thanks to all for your help

[Error404]

Personally, I don't like Banjo fittings on calipers - you tend to need to over tighten them and they are easy to strip the threads in the caliper. Also if you notice, the fitting boss on the caliper is often pitted, meaning they don't seal very well.
If its not too late to change, i'd use a male swivel fitting direct in the caliper. Just my 2c.

[Rikki Kitto]

https://www.helperformance.com/

Get them made up to order to your own spec, easy to do on the website get them within 3 days from order going through great service

[Rikki Kitto]

Just realised you've done it already

[tango123]

i see your point but the mechanic/ friend helping me do the s2 to rs2 conversion told me to go with banjo