Hi guys i know this is a donk question but i need to re.thread my caliper iv got a tool the question is that the tool iv got looks like a course thread it states m10 X 1.5 is this a metric thread? and is it ok to use.
-
-
sounds metric , see if the "tool" mates up to the bolt that goes into the hole your trying to rethread , if they dont mesh together nicely its either too course or too fine
hope that makes senseNOT a car dealer! just an S2/RS2 enthusiast -
cheers will try later.Comment
-
M10x1 is what you need. BTDTCheers'en, AndyC
1994 ABY Coupe - Projekt AlpinweissComment
-
Try and thread a nut on to it and the nippleComment
-
Cheers rusty you were spot on
all done i at to go and buy the tool just for 5mins work. but i suppose £3.99 is better than a new caliper tho or £15 for a rethread at my local engineers.
Comment
-
No worries
I had to re-thread one of mine many years ago, after is got chewed up. I used a pillar drill to guide it it straight and then did all the threads on both callipers. A rather productive lunch break
Cheers'en, AndyC
1994 ABY Coupe - Projekt AlpinweissComment
Comment