RS2 Brake Caliper Pad Sliders

[BosnianS2]

Hello Friends,

I was wondering if anybody had a part numbers for brake caliper brake sliders and screws that hold them in place for front and rear RS2 calipers?
Note: I have 304mm front brake set up.

Thanks in advance for all input

[veneto rs2]

8A0698430 upper fronts stock disc 304mm
8A0698430A lower fronts stock disc 304mm
8A0698630 upper rears
8A0698630A lower rears

the part number it's for two of each type the list above gives you then a complete cover for the four calipers
screws are coming inside the packaging

Stefano

[BosnianS2]

Thank you very much, now i can go order some parts and finaly get my brakes done . Should I order at Porsche or Audi dealer?

[veneto rs2]

Thank you very much, now i can go order some parts and finaly get my brakes done . Should I order at Porsche or Audi dealer?

You can't order in Porsche with those numbers.

Anyway I just did my rears one and done a little research on the web and asked also at Porsche dealer.
Eventually I got them from Audi because I have a good discount at my local dealer the difference it's minimal anyway as far as I remember.

you should spend 100/120 euros for all of them.

The parts are coming on Brembo packaging.....

Stefano

[BosnianS2]

Sounds like a plan. Thanks one more time

[portzi]

hELLO, I HAVE JUST STRIPPED DOWN MY REAR CALIPERS , AND WANT TO DO THE FRONTS AND REPLACE THE STAINLESS STEEL CAGES THAT HOLD THE PAD IN PLACE, ARE THE ABOVE NUMBERS CORRECT FOR THE "LITTLE REDS ON THE RS2. WHERE TO GET THEM IN THE UK AS EURO CAR PARTS AND GSF DONT RECOGNISE THOSE PART NUMBERS

REGARDS
MARK

[europeanme]

hELLO, I HAVE JUST STIPPED DOWN MY REAR CALIPERS , AND WANT TO DO THE FRONTS AND REPLACE THE STAINLESS STEEL CAGES THAT HOLD THE PAD IN PLACE, ARE THE ABOVE NUMBERS CORRECT FOR THE "LITTLE REDS ON THE RS2. WHERE TO GET THEM IN THE UK AS EURO CAR PARTS AND GSF DONT RECOGNISE THOSE PART NUMBERS

REGARDS
MARK

what is the part number on the caliper (99*) number and I'll speak to a contact at Nottingham Porsche...

Mike

[portzi]

Hi Mike thanks for the swift reply. I will have a look tomorrow evening. Where is the number usually located?

Mark

[BosnianS2]

Hello Friends,

I just got email from Audi dealer after looooong wait, that this caliper slider repair set -8A0698430 upper fronts stock disc 304mm- is NLA.
Does anybody know where I can get one of these so I can complete my caliper rebuild?

Thanks in advance

[rynaqui]

Hello Friends,

I just got email from Audi dealer after looooong wait, that this caliper slider repair set -8A0698430 upper fronts stock disc 304mm- is NLA.
Does anybody know where I can get one of these so I can complete my caliper rebuild?

Thanks in advance

Being a brembo caliper, for my 996.351.425/6 calipers, I got all sorts of service parts from:

http://www.pro-calipers.co.uk/

Maybe they can help you out?

[BosnianS2]

Being a brembo caliper, for my 996.351.425/6 calipers, I got all sorts of service parts from:

http://www.pro-calipers.co.uk/

Maybe they can help you out?

Ok, i will try them out. thanks for the info