Have a problem with the brake pedal being fairly firm after startup, then it settles after medium braking a couple of times. I would think it may be the hydraulic fluid which is the problem so which is the best point to drain the whole system and thoroughly, from the bomb? Never changed in the two years of ownership, was thinking since the brakes have recently been properly bled upgraded/rebuilt that the hydraulic system is not providing the required assistance due to bad fluid as it could before.
Also would about 1 litre of G002000 enough for the whole system once bled? I guess about two would be better to properly flush it knowing the crud that will probably come out! Also after the peddle softens, the ABS light comes on, not sure if this is connected but I have had two rear wheel bearings and two rear ABS sensors fitted so will need some checking, any advice is appreciated
Also would about 1 litre of G002000 enough for the whole system once bled? I guess about two would be better to properly flush it knowing the crud that will probably come out! Also after the peddle softens, the ABS light comes on, not sure if this is connected but I have had two rear wheel bearings and two rear ABS sensors fitted so will need some checking, any advice is appreciated
Comment