seem to have a problem with my o/s rear brake cluster.Changed the complete bulb holder and new bulbs but no joy it doesnt wanna work!Any ideas im guessing sumat to do with water leak or maybe electrical fault?
-
Looking for an S2 ABY
-
Hi Mate,
Have you had a look at the wiring where it passes into the body near the hinge on the boot lid. This can crack and cause problems...
HTH
Cheers,
SteveThe Perfectionist
sigpic
Audi Class Concours winner Stoner Park 2014, ADI Concours D'Elegance Class Winner 2008, Runner up 2014. Winner, S2Forum Show'n'Shine Billing 2006 & 2008.
-
which colour wire am i looking for?Or just the bunch of wires that go through the rear o/s panel?Looking for an S2 ABYComment
-
Don't know the colours or how many there are. You will have to wait for an expert to turn up!
Cheers,
Steve.The Perfectionist
sigpic
Audi Class Concours winner Stoner Park 2014, ADI Concours D'Elegance Class Winner 2008, Runner up 2014. Winner, S2Forum Show'n'Shine Billing 2006 & 2008.
Comment
-
I had a similiar problem. Best thing to do is to download these 3b electrical schematics from here // right click...Save As >>Originally posted by madS2
Clicky Here
The diagram you need is Schema number 10....the key is a word document.
Also, you could measure the voltage across bulb contact or wire where it connects to the bulb cluster.
Write down the readings that you get form doing this on the good side of the car (eg/ the working light cluster..with the lights switched on of course...brake lights etc will not work of course though!)
Then do the same on the non working side.
Is there a dead wire??
If so then trace it back to teh loom and locate the break// OR// wire a new bit of suitable wire in from the otehr end back to the cluster.
Thats what I had to do anyway!! There may well be a better way to do it
Last edited by s2dude; 20 September 2006, 20:24.Comment
Comment