needed thicker cable att least 35mm2... or 50mm.. i used weldinkable... easy, and cheap, and to connect to the battery.. for lorrys. they DO have dual connektors, and mad for big cables..
-
-
thank you guys!
i think i'll be good with 50mm². but not sure if 1x50 or 2x25...
@ pirvu eugen: did you fit your battery in a t89 coupe?Audi Coupé Quattro 20VComment
-
well.... i just went out to my audi last afternoon and measured that small compartment in the middle. looked good that far... so i grabbed an old battery and stuck it in there.
fittet almost perfectly. but didn't take any picture.
175x175xmax should fit.
bracket for battery and wiring have to be done.
now i have to figure out where i hide that cable properly.
Audi Coupé Quattro 20VComment
-
Don't forget to fuse it near the batterywell.... i just went out to my audi last afternoon and measured that small compartment in the middle. looked good that far... so i grabbed an old battery and stuck it in there.
fittet almost perfectly. but didn't take any picture.
175x175xmax should fit.
bracket for battery and wiring have to be done.
now i have to figure out where i hide that cable properly.
If at first you don't succeed, destroy all evidence that you tried.
-CQ 3b "S2".Comment
-
i put my battery on the right side of the trunk and used a golf 4 battery box(tray and cover) from plastic so i still have the spare wheel
i have a coupe quattro b2 typeaudi coupe quattro b2 2.2 20vt project (573hp-626nm)
TWINCHARGED power,zero lag
AEM W/M injectionComment
Comment