Pre Select Sunroof

[RAOUL]

I have a few motors, think i've got 3x beige setups and 2x platinum, i'll have to check at home.

Hi Acidburn, what sort of money would want for a pre-select motor?

[Acidburn]

motor or motor and panel?

[mcandmar]

@ mcandmar I have tried your solution several times and it does not appear to work.
Can someone sell me a switch please? I think it is that at fault as some positions on the switch does not opperate the roof at all.

Brian

Sounds like the switch alright. You can dismantle the switch and clean the contact track with some electrical cleaner, i did that with mine and it worked fine again. You can do it without removing the switch from the trim panel as the top of it is only clipped on.

Mark.

[RAOUL]

motor or motor and panel?

Just the motor please. I may be in touch again if my switch panel doesnt work.

[Tonks4x4]

OMG I'm loosing patience with this!!!

OMG I'm loosing patience with this!!!

I have bought a new switch and it still doing the same thing.
Has anyone got the exact procedure for setting the correct position on these things before fitting the motor/switch ect.

[HPmuirt]

He Pete, remember that the best motor has my name on it. Still waiting for you to swing by and and collect your boost gauge too

Cheers n

Si

[S2central.net]

I have a 5-page FFP for the pre-select sunroof... I can scan it over the weekend, but meantime here is the important bit ---

"After the sunroof motor and control unit have been assembled together, the motor must be set to the 0 position before installing onthe vehicle. Connect all electrical wiring."

KEEP THE IGNITION KEY OFF

"Then set sunroof control switch to position 2. The sunroof motor goes to 0 position automatically when the ignition is switched on. Then install the motor in the vehicle"