need to remove the engine harness and ecu, were is the ecu located and whats easiest way to remove the harness? any one have some useful hints or tips
thanks, stephen
thanks, stephen
-
-
passenger footwell on the bulkhead - unscrew it and un plug it
Panthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 Avant -
.
ECU is behind the glove box, harness is easiest with engine out so you can get under the battery tray...slow and painfull job if done right.Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
-
ah not so hard then, however, now that i know where it is on a right hand drive im thinking is it same on a left hand drive, since in locations where things are differentComment
-
behind glovebox is your clue - regardless of LHD or RHD...
Take your time studying connectors at ECU for correct removal - they only come out sweet if you treat them right - there are four connectors - each with their locating clip - all different sizes so you can't cross them.Paul Nugent
Webmaster http://S2central.net
Administrator http://S2forum.com
1994 S2 Coupe ABY - aka Project Lazarus
2001 A6 allroad 2.5TDi - family tank
2003 S4 Avant 4.2 V8 - daily burble
Purveyor of HomeFries and Exclusive agent for Samco hose kits (S2/RS2)
There are only 10 kinds of people that understand binary - those that do, and those that don't
Comment
-
yup was mounted on the airduct behind the glove box, the wiring goes through bulkhead in same place as rhd which made it difficult because the pedals and transmission tunnel but not too bad
however there was two connectors and sockets, not four, both came out easy enough. disconnecting from the fuse box pulling it all through the bulkhead took some time especially as some one had already been playing about with the wiringComment
Comment