You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
Just wondering if anyone can confirm that this is the correct Relay in position 3, and more importantly, if it differs from the other "214" relays seen in this photo. In my 7A CQ it is a completely different relay and now that i have converted to "s2 spec" I wanted to confirm that this is the correct ABY Relay and make the change.
Anyone have an aby s2 they can pop the hood on, pull some relays and check? unfortunately the nearest s2 to me is about 20 hours of travel away... Thanks!
@Ruffiano - that loose relay carrier you have on the loom cannot be for main relay #3 - it must the afterun pump controller which lives in the aux relay panel... Look at my ABY wiring guide PDF... Or am I getting wrong end of things here ?
Not sure if I follow Paul, The loose relay connection now has the afterrun relay from the donor S4 plugged in and is on the auxiliary panel. However this conversation does regard the other thread about the wiring that i started a couple months ago that you were quite helpful in, in post #79 of that thread you said:
Originally posted by S2central.net
T6r/5 needs to extend to terminal K4 on the CEP - that is a new wire to run on your application. See page 9 of my schematic primer doc showing how the 'K' block extends from relay position 3 on the CEP... This is a different relay than used on 7A engine according to relay pinouts shown in Bentley.
I have ran a new wire and integrated into the plug that goes into the backside of the fuse panel, and I am now changing the relay as you stated that is different. The relay that is currently in position three is different then that shown in the picture above. I have a full spare fuse panel with relays that is why i asked if the relay numbered 214 in position three is the same as the other two relays marked 214 in the first picture. I have a spare 214 if this is the case and can plug it in. However i was hesitant about swapping them considering the fact that the 214s i have only have 4 prongs and the relay position 4 allows for several more connections.
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment