hy people.
today I was finish my reborn of 3B engine and everything is fine . the engine run fantastic and now I have to go on next step in my project.
before few years i both a AAN ECU with revo sms chips,ignition coil... everything what is important to start the engine.
I check every part on friends s6 and works fine.
now I want to upgrade the 3B engine loom to AAN.
I know that i have to pull few new wires from ecu to ignition coil. i also have a data wires for aan and 3b.
i know that few people on forum did this project before. and I BEG FOR A HELP from those people.
please help with some advice, how to do it or what I have to put attention on,
there is 55 wires on each side, 110 wires, and I don't wanna mis each of this.
please- any advice is will be good.
thanks ,Igor
today I was finish my reborn of 3B engine and everything is fine . the engine run fantastic and now I have to go on next step in my project.
before few years i both a AAN ECU with revo sms chips,ignition coil... everything what is important to start the engine.
I check every part on friends s6 and works fine.
now I want to upgrade the 3B engine loom to AAN.
I know that i have to pull few new wires from ecu to ignition coil. i also have a data wires for aan and 3b.
i know that few people on forum did this project before. and I BEG FOR A HELP from those people.
please help with some advice, how to do it or what I have to put attention on,
there is 55 wires on each side, 110 wires, and I don't wanna mis each of this.
please- any advice is will be good.
thanks ,Igor