Airbag igniters

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • A80Avant
    S2Forum Obsessed
    • Sep 2005
    • 10873
    • Country: Greece

    #1

    Airbag igniters

    Does anyone knows if these 'igniters' are electrical circuits within the airbag ECU? or somewhere else?
  • bertman
    S2Forum Extremist
    • Apr 2007
    • 1173
    • Current: United Kingdom

    #2
    Was wondering the same thing mate.Have recently had the airbag light come on and after a check with vagcom it told me that the igniter was at fault.
    Have you got an warning light on?
    Rob

    Ragussa green avant RS2+ spec
    Racing blue Octavia VRS mk2 estate-Remapped now to 250 bhp
    Audi coupe gt-slow as hell but loads of character-sold

    Comment

    • A80Avant
      S2Forum Obsessed
      • Sep 2005
      • 10873
      • Country: Greece

      #3
      yes for passenger side belt igniter. i want to try a second hand ecu but since its a bit tidius to reach it, was wondering if anyone knew, so as not to bother!

      Comment

      • A80Avant
        S2Forum Obsessed
        • Sep 2005
        • 10873
        • Country: Greece

        #4
        well i replaced the ECU today but before i did that, i erased the codes and they didnt come up again. Strange, Once i was there i did replace the ecu in the end, but not sure if this was a wire/plug thing in the end. Im hoping it wont come up

        Comment

        • DJones
          S2Forum Fiend
          • Jun 2005
          • 2020
          • Country: United Kingdom

          #5
          Its normally due to poor connectors resulting in the resistance dropping, a good wiggle normally sorts them out..

          Comment

          • A80Avant
            S2Forum Obsessed
            • Sep 2005
            • 10873
            • Country: Greece

            #6
            initially it went ok just by fiddling with the passenger side connector, and i even sliced and used a new connector, but didnt do the job.

            looks like it was the ecu connector instead

            Comment

            • bertman
              S2Forum Extremist
              • Apr 2007
              • 1173
              • Current: United Kingdom

              #7
              Been over the wheel several times wiggling this and that to no avail.Where is the airbag ecu situated on the car exactly,I know it will be in darn hard to reach place like everything else is on these cars
              Rob

              Ragussa green avant RS2+ spec
              Racing blue Octavia VRS mk2 estate-Remapped now to 250 bhp
              Audi coupe gt-slow as hell but loads of character-sold

              Comment

              • A80Avant
                S2Forum Obsessed
                • Sep 2005
                • 10873
                • Country: Greece

                #8
                in mine it is situated in the middle part under the 3 dials. you need to remove the center section(move back the plastic around the handbrake lever), remove the plastic with the 3 gauges completelly, and you will see it hidden in there towards the back with 3 10mm bolts.

                Comment

                • bertman
                  S2Forum Extremist
                  • Apr 2007
                  • 1173
                  • Current: United Kingdom

                  #9
                  ok thanks mate will have a look in that area
                  Rob

                  Ragussa green avant RS2+ spec
                  Racing blue Octavia VRS mk2 estate-Remapped now to 250 bhp
                  Audi coupe gt-slow as hell but loads of character-sold

                  Comment

                  • johne
                    S2Forum Extremist
                    • Apr 2007
                    • 1406
                    • Country: United Kingdom

                    #10
                    Originally posted by A80Avant
                    Does anyone knows if these 'igniters' are electrical circuits within the airbag ECU? or somewhere else?
                    The igniters are the actual circuit within the airbag/seat belt restraint that fire the device. Think of them like an old fashioned flash bulb or fuse that you pump so much electricity through quickly that they burn out instantaneously creating the heat to ignite the airbag gas generator explosion.

                    The airbag ECU checks the ignitor circuit for continuity using a very small current way below that needed to ignite but enough for it to check that there's a circuit and they're still connected

                    John

                    Comment

                    • A80Avant
                      S2Forum Obsessed
                      • Sep 2005
                      • 10873
                      • Country: Greece

                      #11
                      thanks for that info!!

                      Comment

                      Working...