Confused... Wiring 3B into B2...

[poor-boy]

All... I am trying to install a 3B loom into my 90Q B2... All is kind of well with the fuse box I think... but I am not sure what else needs splicing/ adding in??

The main issues are with plugs - T10, T2b, F75, F96, T5K, Code plug and J155 (Relay)...

Any help would be appreicated as wiring is not one of my strong points... Come to think of it nothing is

I have also posted this on Classic Audi...

[poor-boy]

No body....

[S2central.net]

Taff - I sent you a PM... still working on docs for this...

1st thing to say is that there is VERY little you need to actually splice in for 3B loom install onto a B2. Everything on the fusebox is plug and play with the exception of the fuel pump activation signal on the 'B' plug... or the wiper motors (depends how you wanna do that)

2 - ignore the code plug completely

3 - ignore the F75 plug as the B2/KV doesn't have a hydraulic fluid level switch

4 - F96 is the ambient pressure sensor which can be secured to the lower part of passenger side A-pillar to stop if flapping about

5 - Ignore T5k as well - that is for servotronic steering (which you dont have)

6 - T10/T5... this is where most 'vehicle integration' occurs... even I dont know the pinouts from memory

7 - T2b... need to look that up too

8 - J155 for afterrun control - simply plug that relay carrier in the auxiliary panel to hold it nicely

[poor-boy]

Pm rec'd and replied

[S2central.net]

So finally - after much ado - please find sheet attached with a breakdown for this transplant. Sorry for delay... Any questions just shout. The schematic referred to is for MY91 3B engined coupe which can be found at S2central.net where it is referenced as 'A17'.

Enjoy !

[poor-boy]