Hello to all
Recently i bought a cheap VAG-COM 409 (image attached) cable that works fine on a Golf IV TDI.
When i try to conect in my ABY with the engine stopped i can read the engine, abs, aircon and airbag. But when i start the engine i cant connect to the engine ECU (the others i can connect) and VAG-COM 311 shows the message "can't sync baud rate" (image attached). I tried with diferent baud rates (1200, 4800, 9600) but is the same thing (ross tech manual). Only one time the ECU reference started to show and then stop communicating (in the lower baud rate).
Does anyone knows or had the same problem?
There is another type of cable or software to read the engine without problems (to check MAF, lambda, and other sensors)?
Regards
Filipe Araújo
Portugal
Recently i bought a cheap VAG-COM 409 (image attached) cable that works fine on a Golf IV TDI.
When i try to conect in my ABY with the engine stopped i can read the engine, abs, aircon and airbag. But when i start the engine i cant connect to the engine ECU (the others i can connect) and VAG-COM 311 shows the message "can't sync baud rate" (image attached). I tried with diferent baud rates (1200, 4800, 9600) but is the same thing (ross tech manual). Only one time the ECU reference started to show and then stop communicating (in the lower baud rate).
Does anyone knows or had the same problem?
There is another type of cable or software to read the engine without problems (to check MAF, lambda, and other sensors)?
Regards
Filipe Araújo
Portugal