Slc Pure Plus 2 RPM signal

[Simons]

Hi friends, I fit the slc pp2 in an audi s2 3b with pinswap, I took the rpm signal from the ecu connector to the dash, pin 40.

It works fine, but when I pass 2.200 rpms they drop to 0 rpms...when the rpms are reduced, it works fine again, winlog show me the rpms...but when I pass 2.200aprox., again the same problem, 0rpms

Alan told me this
http://14point7.com/forum/index.php?topic=2760.0

And my question is if somebody has the same problem like me and solve it changing the C19 capacitor for another one with lowest capacitance

Thanks!

[Rocco]

I think that none or very few people here are using this logger system

[prj]

It is very simple actually.
Do not take the signal from tacho. Take the signal from ignition coil.

[Simons]

Also I took from pin 1, changed the multiplicant...but it didn't work...0rpm

[prj]

I told you what to do...

[Simons]

Pm sent