Scanning interface and adaptor obd2-2x2. A little help wanted!!!

[FabS6]

hey again mates!

After finding my S6 more scratched than ever because of the ppl's envy in this country, I've been doing today the adapter to my recently arrived VAG-KKL COM to scan my UrS6 (it has the AIRBAG light on since I have a crash last year), I bought 2mt of car audio wires, cuted it in a half and added some pins to plug into the OBD2 interface and into my car's 2x2 obd1 K and L lines. But I have some issues with it, or maybe the interface's driver...i have no idea, first time I'm trying to enter into a non-obd2 and even with a DIY adapter..it doesn't even turn on the led of the interface plug and my PC cannot find the interface with both VCDS and VAG-COM programs. Any idea??? thanx!!!

P.S.: I attached the images of the pin outs and the messages my PC gives me with VCDS and VAG-COM. Ign-key on, engine off, interface connected on PC with "adapter connected to the KKL lines as shown in the first picture.

[ManiacuV6]

I think you don;t have the original VCDS and thee software connected to their website and updated the software in your interface so you cannot use it.

Do you have in the black connector 12 V ? Which software do you use ?

Make sure that you use the software received with your interface !!!

[irishs2]

Make sure you use vcds-lite with 3rd party adapters

http://www.ross-tech.com/vcds-lite/download/index.html

[FabS6]

First of all, THANK YOU both for your answers!!!

I think you don;t have the original VCDS and thee software connected to their website and updated the software in your interface so you cannot use it.

Do you have in the black connector 12 V ? Which software do you use ?

Make sure that you use the software received with your interface !!!

I forgot to make the screenshot with the VCDS-Lite for 3rd party interfaces, but it shows me the same message "Interface: not found". The base software I am using that came with my interfaces is the VAG-COM 409, it's on one of the screenshots!

You will kill me but... I forgont to check if I have 12V on the black connector!

Make sure you use vcds-lite with 3rd party adapters
http://www.ross-tech.com/vcds-lite/download/index.html

I downloaded from right there mate but...... gives me the same problem as the other 2 softs!

[mdz]

Usually there's a CD with drivers and setup instructions included with cable. This looks like driver and/or setup issue.

[FabS6]

Usually there's a CD with drivers and setup instructions included with cable. This looks like driver and/or setup issue.

I'll try again tomo morning as soon as I wake up, but I did it twice already mate! thank you!!!!

[ManiacuV6]

If you used the wrong software you alllready f***ed the interface . But give it a try .

[FabS6]

If you used the wrong software you alllready f***ed the interface . But give it a try .

DA**..... :S I hope I didn't screw it