Couple electrical problems on Urs4

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Majorcina
    S2Forum Extremist
    • Jun 2013
    • 1334
    • Country: Montenegro

    #1

    Couple electrical problems on Urs4

    Well,there are serval problems,but i belive they are related

    1st problem are my electrical mirors,when i try to use them my "relay" (5 amps) burns,
    then i today tryed to conect my electrical seat's and when i conected the memory of seats and try to use it,funy thing happen.

    My left miror started to go up-down-left-right depending which number i press
    Then i toth that i maybe swiched jacks of memory and miror,then i saw they are no near the looks...

    When i drove the car to mehanic so he check if is evrything bloted corrctly they tried to put can on VAG since i have check engine lamp on,and they told me that they was unable to conect the car on diagnostic(i wasnt present when they did it),today i checked if there is any power on black and which jack's and on white there was 12v power(black is ground i sopose)

    Also my rear blinkers dont react for some reason?Front work fine(even they blink faster then normaly-becose rear dont react)

    I belive that this are all my problems
    P.S. Car had full restoration so i belive for all this problems i am the guy to blame
    Last edited by Majorcina; 16 September 2014, 18:21.
  • igor136
    S2Forum Addict
    • Jun 2014
    • 363
    • Country: Croatia

    #2
    Brown is ground. Sounds like a bad ground. Check all fuses.
    1-2-4-5-3

    Comment

    • Majorcina
      S2Forum Extremist
      • Jun 2013
      • 1334
      • Country: Montenegro

      #3
      Grounds are good

      Comment

      • Majorcina
        S2Forum Extremist
        • Jun 2013
        • 1334
        • Country: Montenegro

        #4
        Someone?

        Comment

        • Tonks4x4
          Retired OG Mod
          • Nov 2005
          • 3062
          • Country: United Kingdom

          #5
          Couple electrical problems on Urs4

          Look at the wiring between the door and the a pillar in the rubber bellows as it could be brittle, cracked arking out.
          Last edited by Tonks4x4; 19 September 2014, 21:03. Reason: spelling
          Audi Nut!!!

          Comment

          Working...