Fitting S2 dash w/computer

[mcandmar]

Got my hands on a German S2 dash, KPH Speedo, onboard computer etc to fit to my CQ20v.

1st Q, What’s involved in fitting the computer, what other bits do I need other than the control stalk? Is there a separate wiring loom for it or where does it get its readings from?

2nd Q, If I plug in the S2 KPH Speedo will it be accurate? I assume is uses a VSS signal so is it plug and pray or will it read the wrong speed?

Dare i ask, how do you change the odometer reading so i can set it to match the current milage of the car?

Thanks,

Mark.

[pastures16]

for the 1st one try this link http://www.mnsi.net/~natwhite/Audi/index.htm (upgrades and styling)
2nd dont know
3rd answer try this link it shows you how to strip it down when youve done that theres 6 cogs above the mileage knock out the small pin thats holding this in place then you can put your mileage correct with all numbers inline http://cuatrokoop.audi-quattro.org/index.htm (misc tech writeups) ( cluster repair)

[Beetie]

Hope you mean dials and not complete dash as it will be LHD!

[pastures16]

then the wheel will be on the wrong side now im confused

[mcandmar]

Excellent info thanks

Mark.