stranges on output test

[renoks]

Hello for everyone I did on my s2 3B output test few days ago and I found strange dificulties on test. I mean, when I tested for errors with LED, it worked very fine, but when I try to do test on output, for injectors, isv, ccv, wgsv, I heared clicking just injectors, all other valves didn't klick, but LED was showing that it is on that mode. Then I tested resistence on everyone valve- ok, then crancked engine with LED to test, maybe something with wairing- ok. And my s2 worked and work fine ( I did that test just like routine service). I'm interesting what is not right, couse I did that test many times on mine friends cars and mine ex200 20v- always it worked fine.

[AAH!]

after starting the the injector test cycle and then opening and closing the throttle to test each of the injectors, did you short the diagnostic connectors with a jumper wire for 4 seconds, to start the next test?

as per: http://www.sjmautotechnik.com/troubl...f20v.html#out3

[renoks]

[QUOTE=AAH!]after starting the the injector test cycle and then opening and closing the throttle to test each of the injectors, did you short the diagnostic connectors with a jumper wire for 4 seconds, to start the next test?

Yes, I know very well how to do that test and did many times before like i wrote. That is exactly why I'm writing about, becouse the LED show right, all valves are working, but no any klick at all, exept injectors