!.8T coils in 3B head :(

**urquattro-island** · 4 April 2006, 20:51

hmm

dont think these mix, just make sure that they plug good so no moisture gets down in there..

**Jeffer** · 5 April 2006, 08:56

IIRC someone made the hole larger for the top part of the stem to snug-fit the r/cover. Not sure if this was for the 3B head btw.

**zlobo** · 5 April 2006, 09:17

i got them in mine... and you can fit them under the cower if you peal some plastic of the coils... i post pictures to night

**zlobo** · 5 April 2006, 09:31

here is one and i post an other one on the coil later...

**repo** · 5 April 2006, 11:06

I took off the rubber seal from the coils, and grinded the plastic underneath the seal, so the coil fitted into the hole of the 3b cover.

Also I grinded the collar a little lower from the cover.

Works fine. Took an hour to fit them.

**UrS4boy** · 5 April 2006, 15:30

However you modify the 1.8t "115L" coil packs to fit on/in the 3B head/camcover, make sure that the end of the coil pack goes down deep enough to "snap" on to the hex part of the F5DPOR spark plug.

Dave F.

**zlobo** · 5 April 2006, 18:40

here it is how mine looks

Attached Files

P1030228.JPG (70.1 KB, 102 views)

**audiman** · 5 April 2006, 20:02

Excellent pics and info men!! Is this the same coil part number that a lot of people are now fitting to there cars elsewhere on the forum?? If not can you add the part number please

!.8T coils in 3B head :(

!.8T coils in 3B head :(

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment