Originally posted by porkkis
-
Software is ment for RS2 hardware. So I tried RS2 injectors and fuel pressure regulator, there was no difference - same s*it! -
A-ha. And software is for RS2 ecu right? Changing 300kpa MAP to ABY ECU doesn't make it ADU.-Comment
-
If you know what does, please tell me!Originally posted by porkkisComment
-
PM with instructions on it's way.
It's still a bad idea to use different injectors
-Comment
-
Did you found the problem?
I have the same problem too
I have a costum remap from TS-Tuning with rs2 setup on a ABYComment
-
If the TPS is not working as it should it will over fuel resulting in the end to the turbo and em getting red hot, and Imean glowing red hot.Comment
-
Vag-com says: 00537.
I think it is not TPS.Comment
-
same old story.these faults usually come up when either MAF or lambda sensor is down.i changed both and the fault went awayComment
-
I changed lambda 2 weeks ago and the MAP a half year ago, no results..Comment
-
what lamdba did you choose?also check with a new maf.it cant be anything else with that code,unless you have a major air leak after the maf.
also mafs are many times proven remanufactured and of poor qualityComment
-
I used a bosch lambda, nr : 0 258 003 957, same as audi nr: 034 906 265 F.
I have to do a pressure test, then i know more.
I must have 2 bar turbo pressure, i only reach 1.5 bar.
The car loses much turbo pressure at 5000 rtm, at 6000rtm he has 0.9 bar.
My car has black smoke when I accelerate, he almost switch off when i use the clutch.
And my lambda is very black.Comment
-
tell you what.
look for a leak but replace the lamda again.when i had a different problem and my car was running very rich,i fixed the problem but the lambda was then shot and it had only 10000Kms only.so being rich for a while tends to destroy the lambda sensor.Comment
-
Ok, but my lambda is 2 weeks old, i think a 200 kilometer..Comment
Comment