RS2 spec PRJ chips

[AquaS2]

Is there a way to identify PRJ rs2 spec chips?
Also what would I need to install them onto an ABY s2 with RS2 hardware?

Thanks

[twoqu]

Assuming there is no external ID, one way would be to install them into the ecu and use VCDS to look at the ecu. Usually some info would appear in the relevant field. Another might be to put the fuel/ign chip into a programmer and essentially read the same info off the chip at the relevant address. Depends on what you have access to I guess. Would be a good idea to ID them as there is the difference between RS2/ABY software to factor in.

[orsum]

I have never see my RS2/ABY chips or the ECU mods required to fit them so I cannot comment on what they look like but I can tell you that the Ross-Tech software indicates I have the PRJ stage 3 software.

[prj]

Yeah you can VCDS the ECU and if it's my SW it'll be tagged.

[AquaS2]

Cool, thanks

[Canadian RS2]

Here's what VCDS displays when I scan my Engine Module with PRJ's chipset installed.

Capture.JPG