Turbo oil drain line

[Costash]

I am looking for precision turbo an12 oil drain fittings but I didn't had much luck. What you guys running on t3/4 stile turbos?

[Error404]

If you have some basic dimensions of what you need, I can make you some:

wAMkLmY.jpg

[Costash]

Pmd

[macspring]

wAMkLmY.jpg

They're gorgeous - well impressed - again.

[Pauliusb2]

Error how much is for 2 fittings like in picture?
Thanks

[stin]

Keep in mind that the female AN12 hose end might have problem fitting next to some compressor housings.

[Costash]

It is a bit tight but turbo is out and it is a bit easy. Fingers crossed.

[Error404]

Error how much is for 2 fittings like in picture?
Thanks

Those pictured were machined from 321 stainless and £60 each
My "Standard" ones are machined from 6082 ally and £45 each.

A lot of the cost is in the set-up time, for one-off machining - I could do a cheaper price on 10+ units if anyone else wants some I can price it up.

The -12AN nut is 31.75mm (1.1/4") AF so in this application it looks like it will fit BUT must be fitted to the flange before installation, as you cannot turn the nut in-situ
As Stin rightly says, quite a lot of turbos simply don't have the space for a normal -12AN flange fitting here, but I can machine something special to suit, with an extended neck)

-10AN is perfectly adequate in most scenarios