s2 3b & rods

[Simone Ceola]

hi, to get to 400hp on s2 3b is it necessary to replace the connecting rods? if yes, which are the best?

Inviato dal mio ASUS_X018D utilizzando Tapatalk

[mac2226]

If the turbo your going for has a lot of torque then yes change them

[Simone Ceola]

If the turbo your going for has a lot of torque then yes change them

is garrett gtx3071r gen2

Inviato dal mio ASUS_X018D utilizzando Tapatalk

[mac2226]

I would,Unless you map it torque limited then it defeats the purpose of a bigger turbo. All best Michael

[add]

I'd check out FCP engineering for rods,also not a bad idea to ditch the distributor and go tfsi coils

[Simone Ceola]

I'd check out FCP engineering for rods,also not a bad idea to ditch the distributor and go tfsi coils

thank you.. next step is standalone ecu, in winter season is tfsi coil and rods.

Inviato dal mio ASUS_X018D utilizzando Tapatalk