Hi,
Looking for some help again!
I'm rebuilding my AAN and installing Wossner 81.50mm piston.
The machine shop set the piston to wall clearence of 0.07mm, as stated on the box.
My question is abouy ring gap, as I didnt find any definitive anwser after some search. Out of the box they are:
1st: 0.30mm
2nd: 0.35mm
Oil: 0.40mm
I'm running 1.8bar. Do you think those gaps are suficient?
Regards
Looking for some help again!
I'm rebuilding my AAN and installing Wossner 81.50mm piston.
The machine shop set the piston to wall clearence of 0.07mm, as stated on the box.
My question is abouy ring gap, as I didnt find any definitive anwser after some search. Out of the box they are:
1st: 0.30mm
2nd: 0.35mm
Oil: 0.40mm
I'm running 1.8bar. Do you think those gaps are suficient?
Regards
Comment