How to get a AAN engine to 400bhp?

[K7ERG]

What is needed to get the AAN engine to 400bhp?

Craig

[Knight Rider S4]

Read the spec on the this car give you ideas...the one i was talking about the other day... drool drool

http://www.s2forum.com/forum/showthread.php?t=20073

[Knight Rider S4]

did you go and see the S4 then?

[K7ERG]

Going to have a look today mate. Just looking at my options for power before i decide.

Craig

[K7ERG]

What turbo will see 400bhp on this engine?

I see the 7a cams are a common mod

So all i need is bigger injectors,fuel pump,intercooler,turbo, cams and a remap.

Craig

[Jamo]

Read the thread project 400 by ross.

Garrett 3071 will get you over 400 with minimal lag when compared to a KKK alternative.

[K7ERG]

Thanks is the thread in the turbo section?

[Jamo]

http://www.s2forum.com/forum/showthread.php?t=16552

[K7ERG]

Thanks for the link mate

[K7ERG]

Read the thread project 400 by ross.

Garrett 3071 will get you over 400 with minimal lag when compared to a KKK alternative.

I have asked a German tuning company (Vmax) about the above turbo and they said i would be better with the GT3076R exhaust housing with a/r .82

?

Any opinions

Craig

[Jamo]

I have asked a German tuning company (Vmax) about the above turbo and they said i would be better with the GT3076R exhaust housing with a/r .82

?

Any opinions

Craig

A 3076 is a good turbo pushing into the 500 bhp range Sal_S2 had one but the Gt3071r spool time is nearly the same as a K24 meaning no more lag than stock.

3071 is before 4000 rpm whilst easily making 425-450 bhp minimum with a .63 A
The .82 AR on a 3076 would push the full boost into the 4000 rpm range it's too big IMO

Read here http://www.034motorsport.com/product...128afb9ea4b1fc speak to Corey who sells them for a living. End of the day pays your money and make your own choice

[MidnightBlueS2]

Or one of MRC's KKK hybrids.... Fits stock RS2 EM and stock exhaust. Full boost only 500rpm later than stock K24 7000.

My only choice as I need to fit my stock exhaust to it to get past Belgian Tech Control (MOT)

[Corey]

Fits stock RS2 EM and stock exhaust.

The 3071 can be ordered to fit for the stock location, the only part that needs changing from stock are the oil/water lines which we supply also.