My car is running a stage 1 chip and I will hopefully be upgrading to Pauls homefries in the near future. Is it beneficial to get a 3 bar vmap fitted or would this be better when I upgrade to a rs2/gt turbo and chipset?
-
100 Avant S4 :bow:
HP2 struts with S6 calipers
Stage 1 MTM Chips :chit:
Stromung Exhaust System :bow:
Bosch 005 Fuel Pump
Lowered 30/40mm H&R Springs
Turbosmart Kompact BOV
Autometer Phantom Boost/Volts guages -
Wait until you change the turbo.Kingdoms are run by Kings, Dictatorships are run by Dictators.
England must be a Country. :mischeif: -
Correct me if i'm wrong but a home fry chip wont work with a vmap sensor?
The readings from the sensor have to be calibrated on mapping to compensate for the difference between OEM and VMAP.Comment
-
A homefry won't work right with any 3 bar MAP sensor AFAIK.
Wait for the upgrade.SSComment
-
Just found this thread - its a no brainer to tweak the 'homefry' for 3bar MAP or VMAP if there is sufficient demand for it.
PaulPaul Nugent
Webmaster http://S2central.net
Administrator http://S2forum.com
1994 S2 Coupe ABY - aka Project Lazarus
2001 A6 allroad 2.5TDi - family tank
2003 S4 Avant 4.2 V8 - daily burble
Purveyor of HomeFries and Exclusive agent for Samco hose kits (S2/RS2)
There are only 10 kinds of people that understand binary - those that do, and those that don't
Comment
Comment