kkk turbo p/n and compressor map needed..

**Knight Rider S4** · 3 April 2007, 09:50

Could you post some pics up of turbo

**Mihnea** · 6 April 2007, 14:23

The wheel is probably a 3272 wheel, I don't have a compressor map for it but honestly it's CR@P. We have used it ages ago in Doug's car and the results weren't good at all, 440-450 crank HP at high revs but almost no torque down low and it just took ages to spool. Made the car feel like it had a massive normally aspirated engine in it.

**audi660** · 7 April 2007, 00:15

What would be the best comp wheel to use with a kkk 26 shaft?

**Mihnea** · 7 April 2007, 10:24

3072 is the best for a K26 shaft.

**porkkis** · 7 April 2007, 15:29

Shouldn't we say that it also depends on the hot side. 3072 is what MTM used in their 380hp package with #8 hot side. Not too fast spooler neighter what I've heard.
I have a map for that but not for 3272.

What's Mihnea's opinion on 2970 and 3262? 3262 should be more "modern" so I've been told but of course with its ~51mm inducer it's no 400+ compressor.

**Mihnea** · 7 April 2007, 18:52

3072 is the comp wheel MTM use for the 428 kit too BTW. We've dynoed 438 on 2 different MAHAs on Doug's car with that compressor and K26#8 hot side. That's the turbo pushed to the max of the hot side capacity and boost was still relatively moderate. Any more than that and you lose what boost gains you by trading off timing.

I think Jeffry has the 2970 comp wheel in his car, or maybe a 3270, can't remember for sure, but he has a K27#7 hot side so no real comparison. IMHO for 400-480 maybe 500 crank the GT3071 is a pretty good alternative... never tried 3262 and it does sound quite small to me and not super efficient for high power.

HTH,

Mihnea

**audi660** · 1 May 2007, 13:31

What are the measurements for a 3072 comp wheel?

kkk turbo p/n and compressor map needed..

kkk turbo p/n and compressor map needed..

Comment

Comment

Comment

Comment

Comment

Comment

Comment