Anyone know the correct torque settings for the knock sensors.
Wanted to make sure I have done them right.
Thanks
Ian
Wanted to make sure I have done them right.
Thanks
Ian
-
1991 S2 3b, Samco Hoses, RS2 IC, 18'' RS6 Wheels, Forge Dump Valve, Scorpion Exhaust System, Decatted, MRC Remap
-
I'm not sure what the correct torque settings are for the knock sensors but great care must be taken when tightening them as the crystal inside can easily be damaged as a result of over tighteningS2 Avant......fully loaded :rock: :bow: Slipper Wagons Rule !!!!! -
Sorry to jump in on this one but it is on topic....
I have got two cracked knock sensors....
Per chnace are they the same ones as used on the 7A engine???
CheersDark Grey Avant
RS2 FARB
Powerflex Front wishbone bushes
Alloy Subframe BushesComment
-
-
Tightening torque for the knock sensors for the 7A is 10NM, part no.s are
054 905 377C,
054 905 377B.
if this helps.Carlos.
On the look out for less bits for my s2 saloon project. Now supporting myself by shooting for my food. www.airgunforum.co.ukComment
Comment