~400hp

**DJones** · 14 September 2007, 20:09

Yep they will be fine..

**Pirvu Eugen** · 14 September 2007, 20:12

nice to here this.
thanks!

**MidnightBlueS2** · 14 September 2007, 20:21

Originally posted by DJones

Yep they will be fine..

Second that...

Careful when mapping though, 400 hp yes, but if your turbo can deliver more than 500Nm - 400lb/ft of torque, you'll be going out on limb and your stock rods could bend

**Acidburn** · 14 September 2007, 20:21

IIRC prosty said they are good for something like 650bhp?

**Pirvu Eugen** · 14 September 2007, 20:27

don't push me! i am at the edge of madness already!

**LHD_Kid** · 14 September 2007, 20:30

Heyyyyyyy it's my job to poke Eugen for going SERIOUS power...........

You'll need some rods.....anybody got a set to sell him, as I want him to hurry up and get it done....

**Pirvu Eugen** · 14 September 2007, 20:33

soooooo! you are the oneeee!

thanks!

**Pirvu Eugen** · 15 September 2007, 15:15

Hy guys! I saw that the AAN, ABY,ADU ECu's have an input signal from the vehicle speed sensor. Problem is that I have cable speedometer. Is any problem if the ecu will not have this signal?
Thanks!
I have untill now the AAN ecu, 420 cc at 3 bar injectors, 7A cams, an complete 3b engine to dismantle.
I was wondering What turbo should i get for 400-420 hp. I will have an ~50% bigger intercooler, reversed intake manifold, and tubular EM. I am looking for high torque rather big power.
Thanks!

**Cullam3n** · 15 September 2007, 15:21

iirc I don't think it will not let the engine start (cut spark out), but I'm sure someone will correct me

**Pirvu Eugen** · 15 September 2007, 15:24

Hope not!

**kwlw** · 15 September 2007, 17:25

Originally posted by Cullam3n

iirc I don't think it will not let the engine start (cut spark out), but I'm sure someone will correct me

It just there for speed limiter IMO. No real problems with AAN's without this signal.

Sau

**DJones** · 15 September 2007, 20:09

I have an AAN in my ur no speed sender and no problem.

**Pirvu Eugen** · 15 September 2007, 20:15

Glad to hear this because , if i understand right, the AAN is much more reliable and tunable as 3B.
Thank You very much!
You are great!

Eugen

**Pirvu Eugen** · 15 September 2007, 20:17

What about the turbo? Definetly i have to go to GT 3071R, or there are some other turbos for 400 hp with low rev torque?
Thank You!

~400hp

~400hp

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment