How to get the RS2 timing?

[S2central.net]

Uhhh - I wrote that of course... I don't see what you are referring to on that document in respect to this question.


Paul

[MarT2]

Uhhh - I wrote that of course... I don't see what you are referring to on that document in respect to this question.


Paul

I don't understand...

[UrS4boy]

Uhhh - I wrote that of course... I don't see what you are referring to on that document in respect to this question. Paul

I am guessing it's the number of teeth on the timing belt. 151 vs. ??? (I checked ETKA. AAN says Z = 151, ADU says nothing, nada. )

Personally, I am hoping somebody will post a photo of the ADU and ABY/AAN cam sprocket (both sides) so we can see the difference, e.g. the hall sender trigger position (I have heard both 5 deg and 10 deg differences so far). I am guessing that this hard advance (retardation?) of the hall sender signal isn't really important if you have a tuner, e.g. MRC, modify your timing accordingly. Probably a limit to that option though.

[Keith]

Uhhh - I wrote that of course... I don't see what you are referring to on that document in respect to this question.


Paul

We' re talking about if there's a difference between ADU/ABY's Camshaft pulley.
I thought (might be wrong) that point 10 on your chart page 2 "toothed belt crank pulley" was the camshaft pulley, and that according to that both were the same part!

Was I wrong ?

[Keith]

RS2 cam wheel changes only the hall sender signal timing, no change to the cam timing.

well,

ABY's has the hall sender too !!!!!

Keith