3 pin temp sender VS. 4 pin temp sender

[Tommen]

I will replace the temp sender on my Rs2, since I have the radiator ++ out, BUT is it the same sender??

The part number is 034 919 369C on ETKA I think....

And is the number for the after run pump switch 054 919 369B ?



Tom.

[s2driveruk]

the sender was updated to a 3 pin variant so yes should be the same even though it no longer has four pins on it.

[Tommen]

OK, thank's for the info!

And VAG-parts is the best dealer on this?

[Tommen]

Finally got the temp sender from VagParts, but then I got another problem… There are 4 wires and only 3 pins and the socket fits both ways!!

Witch one shall not be connected??

[UrS4boy]

I will replace the temp sender on my Rs2, since I have the radiator ++ out, BUT is it the same sender??
The part number is 034 919 369C on ETKA I think....
And is the number for the after run pump switch 054 919 369B ? Tom.

Tom: Your part numbers are correct. The answer to your 4 pin vs 3 pin MFTS question can be found at:

http://www.sjmautotechnik.com/trouble_shooting/cooling.html#gauge

Dave F.

[S2central.net]

The 3-pin sensor does NOT require the 12V supply that is present on 4-pin connector.

[Tommen]

Nice! Thanks for the replies.