engine setup, any suggestions?

[lind4hl]

hello, what do you think of my engine setup? any changes?

new pistonrings
new bearings etc.
new rods (stronger, scat etc)
intake from pogea
intercooler from pogea
ported head/ refirbished
7a intage cam/ rs2 exhaustcam
another exhaust manifold, (homemade)
precision sc61 turbo
org wastegate
open airfilter
bigger oilcooler
titanium retainers
harder valve springs
better clutch
VEMS aftermarket fuel/ignition system

500bhp? possible?

[A80Avant]

why 7A intake and RS2 exhaust?you should have it the other way around.There will be more lag this way and none benefit on the high rev range!

[lind4hl]

hm okey, many that runs 7a inlet cam in sweden, but 7a exhaust and rs2 inlet?

[A80Avant]

the 7A exhaust will give you more power in higher revs,at least this is what most have done here that i have read about

[lind4hl]

okey, good then i will have 7a exhaust and rs2 intake, (who the hell needs power on low revs )

do you think its 500bhp possible? ive heardthat you dont need to change the pistons befor 800bhp`?

[vcosmin]

okey, good then i will have 7a exhaust and rs2 intake, (who the hell needs power on low revs )

do you think its 500bhp possible? ive heardthat you dont need to change the pistons befor 800bhp`?

I think that was more like 550-600hp, for pistons

[gedu]

well, at least modified stock pistons can run for 700 range, but you really do need to modify them to lower compression. They are strong ones, but they do have their limits. You really have to think about fueling part, when shooting for that kind of power

[lind4hl]

fueling will be an pump in original case and tank, 8 or 10mm stainless steel fuellines fuellab fpr braided hoses with an fittings, 034 fuelrail aeromotive fuelfiter and so on.