Trying to change my hall sensor

[AUDIS2avant]

can anybody help me here a little?
I cant seem to get the aux rad out, it´s loose but is stuck in the rubber thingies?
What about timing when i have to take the cam pully off?

Have SERIUSLY tried to find a topic about it but havent got any luck

Do i have to take the bumper of to fix this?

[Jamo]

There's a load of them!

The rubber mounts have nuts under them, you have to loosen the nuts before you can take the Aux rad out.

Set the car to TDC and use cable ties to tie the belt to the cam wheel so the timing is not lost.

[Jamo]

Use this as posted on here by UrS4boy http://forums.audiworld.com/s4s6/msgs/195605.phtml

[AUDIS2avant]

thanx jamo

[S2central.net]

THere is this one too remember ----->

http://www.s2central.net/auxrad.html

Most important for the cam pulley bolt - you MUST counterhold the pulley with a suitable tool - or get the cam cover off to get a big wrench onto the EX cam if nothing is suitable for holding the pulley.

[AUDIS2avant]

Thanx guys.
I got it changed without removing the auxrad, wasent so bad, but it coast me a cambelt cover as it got stuck under the servopump
Car dident start right away, but it was down on batteri so maybe that was the fault.
Old sensor was completly destroyd, so was a good thing i got it changed, but i have a feeling that this was not the only fault
Thanx for your help for now

[Jamo]

Heh funny that I just changed mine today on the new engine, easy with no cambelt lol

[AUDIS2avant]

I bet that was easy then LOL