Boost levels on a Nothelle?

[Key Walshe]

After receiving my new Roose hoses yesterday, I quickly fitted the three main air intake ones to get it running as it should - the temporary repair had given up - and with the S2 pulling like a train again, I was wondering what boost levels it should be running at? From what I can see on the gauge it's spiking at around 1.4bar, is this right? Too high, too low maybe?

This goes out to any Nothelle N300 owners, the likes of ericd, or also to anyone else on here who's an S2 buff who knows... I have done a search too, found various amounts and all on differing spec cars so it's hard to judge!

Thanks

[ericd]

It is indeed supposed to boost to 1.4 bar, , try and get it on the rollers now you think you've got it fixed, you might get a wee suprise as they never seem to be exactly on the supposed output of 315hp/333lb ft (450Nm), last time I checked mine was 340hp/380lb ft (500Nm), but remember output can go down as well as up

[Key Walshe]

Chess Eric, knew you'd be along sooner or later with the info needed! That's very impressive from yours, I'll keep my fingers crossed that mine is able to put out atleast the claimed power figures.

Running with full Milltek system, k&n panel filter and an RS2 maf - plus the full Roose setup so hopefully it should give out a good figure as a dyno run is something I'd like to do soon