I found out that the stock pump in the RS2 is almost dead so i "stole" the not yet mounted 044 pump for my S6 project.
I studied this thread http://www.s2forum.com/forum/showthread.php?t=14698 And modified that mesh bit so the pump would slip in. But the next part where it says that the pump has 2 grooves so you need to cut some grooves in the basket so it slips further down..
Well... my 044 pump has 1 huge groove that goes around the whole pump so i'm def not sure to make that sqeeze even further down..
Any sugestions?
Pics below to ilustrate my problem
I studied this thread http://www.s2forum.com/forum/showthread.php?t=14698 And modified that mesh bit so the pump would slip in. But the next part where it says that the pump has 2 grooves so you need to cut some grooves in the basket so it slips further down..
Well... my 044 pump has 1 huge groove that goes around the whole pump so i'm def not sure to make that sqeeze even further down..
Any sugestions?
Pics below to ilustrate my problem
Comment